Cmake command not found mac6/1/2023 However, old versions of CMake might get confused if you have multiple versions of Python installed (for example on a Mac with Homebrew), and find the headers for one version and the binary for another. If using a recent version of CMake (3.14 or later) it should have no issues in doing so. In order to build IMP Python extensions, CMake needs to find the Python header and library files that match the python3, python2 or python binary. CMAKE_INSTALL_PREFIX should be set if you want to install IMP in a non-standard location.For example, on a 32-bit RHEL5 system, which has both Boost and HDF5 in non-standard locations, we use -DCMAKE_INCLUDE_PATH="/usr/include/boost141 /usr/include/hdf518/" -DCMAKE_LIBRARY_PATH="/usr/lib/boost141 /usr/lib/hdf518" If your libraries are installed in non-standard locations, you can set these variables to help CMake find them. CMAKE_INCLUDE_PATH and CMAKE_LIBRARY_PATH control the paths CMake searches in to locate IMP prerequisite libraries.There also are a variety of standard cmake options which control the build. USE_PYTHON2: Set to on to have CMake build IMP with Python 2 (by default it will use Python 3 if available).IMP_PER_CPP_COMPILATION: A colon-separated list of modules to build one.IMP_MAX_LOG: One of SILENT, PROGRESS, TERSE, VERBOSE to control what log levels are supported.The default is USAGE for release builds and INTERNAL for debug builds (setting this to INTERNAL will impact performance NONE is not recommended as all sanity checks will be skipped). IMP_MAX_CHECKS: One of NONE, USAGE, INTERNAL to control what check levels will be supported.IMP_DISABLED_MODULES: A colon-separated list of disabled modules.CMAKE_BUILD_TYPE: one of Debug or Release.imp) or by passing them with -D in a call to cmake. These can be set interactively using ccmake (eg ccmake. Various aspects of IMP build behavior can be controlled via variables. That is highly recommended when it is available. You can use Ninja instead if it is available by passing -G Ninja to the (c)cmake call. You can run ccmake after running cmake as above if you want, too. Tell cmake to configure (hit c) and generate (hit g).If you want a debug build, set CMAKE_BUILD_TYPE to Debug.imp You can then look through the various options available. imp -DCMAKE_BUILD_TYPE=Debug -G Ninja -DIMP_DISABLED_MODULES=cgal:membrane -DIMP_PER_CPP_COMPILATION=core To make a debug build of IMP with the cgal and membrane modules disabled and core compiled in per-cpp mode, and to use Ninja instead of make as your build command do: cmake. To configure and build as simply as possible do cmake. We are using the default of makefiles for the actual building.Ĭonfiguring with cmake command line options For both, assume you are in a directory called debug and the IMP source is in a directory at. There are two different ways to configure with cmake one is to run cmake in a fresh directory passing some options on the command line, and the other is to run ccmake and use its editor to change options. We use CMake to configure the IMP build when building from source.
0 Comments
Leave a Reply. |