Trimetric battery monitor amazon5/31/2023 ![]() Your email address will not be published. For example, if you are only using one battery, P3 would be set to 100 because you have a 100 Ah capacity. P3: Change this number to match the size of your Battle Born Battery bank’s capacity. Here are the values mentioned above that the charge controller needs to be set to: Change P3’s value to the capacity of your Battle Born Battery bank size and Change P10 to 98. Press Select to move to P2. As in step 2, change P2’s value to 2. This same process will be used to adjust each of the following parameters.ģ. A green light on the unit will flash, signifying that you are in Change Mode. Press Reset to change P1’s value to 14.4. At the same time, briefly press Select and Reset and then let go. Press and hold Select until P1 appears.Ģ. Definitely would have been nice to have lower price, but has mid point battery string monitoring and can do parallel strings, may be worth the price, time and being used by some of the knowledgable people on this site. Flush mount or use wiremold box to mount. The positive lead to the TriMetric should be fused with a 1-amp fuse. Here is how to set up a Trimetric TM-2030 battery monitor and Bogart Engineering solar charge controller to operate with Battle Born Batteries:ġ. Allows for a maximum battery bank size of 2500 amp-hours. ![]()
0 Comments
Leave a Reply. |